|Place of Origin:||China|
|Certification:||ISO9001, ROHS, CE|
The dummy load of the high-frequency transmitting circuit is mainly to allow the frequency, the impedance should be matched, and it can withstand the transmitted power. It can usually be used to test the power of long-wave, medium-wave and short-wave broadcast transmitters. Simply put, it is a radio frequency 50 ohm resistor that can withstand high power, and the standing wave coefficient is very small. It is used to test the transmitter, instead of the real load. The special equipment converts all the radio frequency energy input into it into heat and dissipates it. For the transmitter to Say, the dummy load provides a perfect 50 ohm impedance.
The TPW-LPT200-827-160-41M RF load (also known as a terminal or dummy load) has a 4.3-10 male connector. This Topwave 200 watt 4.3-10 male load/terminal is rated for a maximum frequency of 2700MHz. Our 4.3-10 male terminated loads are RF load terminations with 50 ohm impedance. At the same time, its PIM value is -160dBc.
|Power Rating(W)||200W (average power per port)|
|Operating Tem(℃)||-25°C to +50°C|
|Dimensions(mm)||See mechanical Drawing|
ROHS & CE Compliance
Guaranteed PIM Guaranteed -160dBc
Wide Frequency Band Covering 790-2700MHz
Low Insertion Loss & Low VSWR
Available with Type N, 7/16DIN or 4.3/10 Connectors
Widely for Distributed Antenna(DAS) Solutions.
Well Installed in In-building System(IBS)